HBM portable induction device

For quick release of bolts and nuts. Special features: Heating makes it easier to remove bolts, nuts and bearings without using an open flame. Is suitable for heating any type of magnetic metal. Advantages: Time saving: fast, extremely accurate heating. Fireproof: produces no flames, maximum safety for the user. Functional: can be used with one hand, adapter adapters can easily be changed. Applicable in: Automotive industry, Industrial maintenance, Aviation industry, Marine industry, Petrochemical industry.

1. This device is built into the overheat protection, switches itself off to prevent overheating and can normalize the temperature after use. 2. Please do not use it for longer than 2 minutes. Although the device is built into overheating protection, you should not use it often until the power switch turns off the power. This shortens the life of the device. 3. Place the coil in the middle of the bolt during use. Do not try to block the back-end fan during operation, otherwise the cooling capacity will decrease and the device will overheat very quickly. 6. Do not place this device in the refrigerator near the air conditioner. Otherwise water can condense in the unit and the board can be damaged. Do not reach or approach large metal parts (this is the place where you do not need to heat). Otherwise, the workload and the slow heating speed lock increase. Note the following image. 4. If the insulation is damaged, replace it with a new insulation hose or replace the coil. (Breakthrough of the insulation tube can cause the induction coil to become too short, which reduces the heating function and increases the working load of the device.) Working capacity (size of the bolt is 22 mm) Working hours: Lasts 2 minutes. (From the normal temperature to the protection temperature when switching off); Reference of heating capacity: Heating of 3 pieces of bolts from 25 ° C to 300 ° C

1. Loosen the 2 fixing screws 0.5 cm counterclockwise. 2. Choose the coil size that is suitable for your task and insert the two ends into the front holes. 3. Turn the bolt clockwise to secure the bobbin. 4. Place the heating element and place it in the center of the coil. Then hold down the red button and the headlight comes on at the same time. 5. At the same time, when the work is complete, the temperature of the heating elements will rise, release the button and keep it in a safe place.

Article number: 6760-E

Note: Import Taxes and Duties still need to be paid for shipments to Norway, Switzerland